My Cart
Manufacturer: Workhorse
Model: 52455276
52455276 - Seal Kit - Engine Oil Cooler LineThis kit includes 2 O-Rings that are the same size.Tighten the block fitting bolt to 35 Nm (26 lb ft). (DO NOT OVER-TIGHTEN as it will distort the oil cooler connection block and cause it to leak!!)..
$20.13 $20.72
In Stock
Manufacturer: Workhorse
Model: 88984269
88984269 - Workhorse 8.1L (03-11) Spark Plug Wire Kit..
$191.61 $258.67
Out of Stock
Manufacturer: Workhorse
Model: 89017574R
This is a used pull out part. They are sent to a machine shop to inspect
and remove any major defects but we can't 100% guarantee that it won't
require any grinding...
$843.75 $1,912.77
Out of Stock
Manufacturer: Workhorse
Model: 89060436
89060436 - Seal Asm - Crank Shaft Rear Oil..
$61.47 $64.44
Out of Stock
Manufacturer: Workhorse
Model: A40-A50-TCM
This a NEW replacement TCM for the 2006+ Workhorses and C4500/C5500 with Allison Transmission. Module will come programmed to your VIN, plug and play. We will need some information from the back of your existing TCM, the TCM+Cal Assy # and CIN # in order to program correctly.Please Note: Some of the..
$3,795.00
Out of Stock
Manufacturer: Workhorse
Model: EGR81EXH
EGR81EXH - EGR Pipe Block Off Plate (Exhaust Manifold) 8.1L..
$39.50
In Stock
Best Seller
Manufacturer: Koni
Model: 8805-1002
Upgrade the rear suspension performance of your motorhome or commercial chassis with the KONI 8805-1002 Frequency Selective Damping (FSD) Rear Shock, designed for Workhorse W-Series, Workhorse R26 UFO, Workhorse W62, and Chevrolet Kodiak C4500 / C5500 applications with stud top and bottom mounting. ..
$225.00 $229.50
In Stock
Manufacturer: UltraPower
Model: MAG81-1
The UltraPower Magnum High Performance Ignition Coil generates approximately 10% higher output than the factory ignition coil. The higher output will decrease sometimes imperceptible misfires. This is especially advantageous under heavy load conditions. These ignition coils are especially effective ..
$418.82 $499.00
In Stock
Manufacturer: Workhorse
Model: UBW22F
If adding caster shims and/or sway bar/trac bar mounting plates, you may require one or more extended U-bolts. The stock u-bolts are approximately 6" in length, these are 8".These u-bolts come with the necessary nuts and washers for installation...
$43.25 $53.63
In Stock
Manufacturer: Workhorse
Model: UTW449DL
Direct replacement for original Workhorse drag link part # W0000449. Heavy duty construction designed for long service life...
$649.92 $728.14
In Stock
Manufacturer: Workhorse
Model: W0000049
W0000049 - Crossmember - Rear Spring Front, Rear Spring Rear ..
$135.85 $183.40
Out of Stock
